top of page
adobestock_298464892.jpg
LLDPE 218WJ

Mã Sản Phẩm: LLDPE 218WJ

Description

218WJ is a butene Linear Low Density Polyethylene TNPP free grade suitable for general‐purpose packaging. It is easy to process giving good tensile properties, impact strength and optical properties. 218WJ contains slip and antiblock additives.

Melt Flow Index (MI): 

2.0

VTHH

LLDPE FILM

Producer

SABIC

Origin

Arabic

Application

Blowing PE bags, Shopping bags, extruding films....

SABIC® LLDPE
118WJ Linear low density polyethylene for Blown film

Application

Lamination film, thin liners, shopping bags, carrier bags, garbage bags, coextruded films, consumer packaging and other general-purpose applications.

Properties
Values
Units SI
Test methods
Polymer properties
Melt flow rate (MFR)
at 190 °C and 2.16kg
Density
2
g/10 min
ASTM D1238
918
kg/m³
ASTM D1505
Formulation
Slip agent
Anti block
-
-
-
-
Anti oxidant
Optical properties
Haze
at 60°
13
80
%
ASTM D 1709
-
ASTM D2457
Film properties
Impact strength
Tear strength TD
Tear strength MD
Puncture resistance
Tensile test film
stress at break MD
stress at break TD
strain at break MD
strain at break TD
stress at yield MD
stress at yield TD
1% secant modulus MD
1% secant modulus TD
35
29
700
750
12
10
220
260
MPa
MPa
%
%
MPa
MPa
MPa
MPa
ASTM D882
ASTM D882
ASTM D882
ASTM D882
ASTM D882
ASTM D882
ASTM D882
ASTM D882
Puncture resistance
Elemendorf tear strength
MD
63
J/m
ASTM D882
g
130
g
ASTM D1922
Thermal properties
Vicat softening temperature
98
°C
ASTM D1525

PROCESSING CONDITIONS

Typical processing conditions for 218WJ are:

Melt temperature: 185 - 205°C, Blow up ratio: 2.0 - 3.0

 

Health, Safety and Food Contact regulations.

Detailed information is provided in the relevant Material Safety Datasheet and or Standard Food Declaration, available on the Internet (www.sabic.com).

Additional specific information can be requested via your local Sales Office or Contact us via website

DISCLAIMER: This product is not intended for and must not be used in any pharmaceutical/medical applications.

 

Storage and handling.

Polyethylene resin should be stored in a manner to prevent a direct exposure to sunlight and/or heat. The storage area should also be dry and preferably do not exceed 50°C. SABIC would not give warranty to bad storage conditions which may lead to quality deterioration such as color change, bad smell and inadequate product performance. It is advisable to process PE resin within 6 months after delivery.

 

Disclaimer.

DISCLAIMER Any sale by SABIC, its subsidiaries and affiliates (each a “seller”), is made exclusively under seller’s standard conditions of sale (available upon request) unless agreed otherwise in writing and signed on behalf of the seller. While the information contained herein is given in good faith, SELLER MAKES NO WARRANTY, EXPRESS OR IMPLIED, INCLUDING MERCHANTABILITY AND NONINFRINGEMENT OF INTELLECTUAL PROPERTY, NOR ASSUMES ANY LIABILITY, DIRECT OR INDIRECT, WITH RESPECT TO THE PERFORMANCE, SUITABILITY OR FITNESS FOR INTENDED USE OR PURPOSE OF THESE PRODUCTS IN ANY APPLICATION. Each customer must determine the suitability of seller materials for the customer’s particular use through appropriate testing and analysis. No statement by seller concerning a possible use of any product, service or design is intended, or should be construed, to grant any license under any patent or other intellectual property right.

You may also like

bottom of page